SAVIN C2828 DRIVER DOWNLOAD
If you change the development unit, do the ACC procedure. Turn the machine power off. Keep the developer off at both ends of the development unit enclosed in red lines in the diagram. Open the drum positioning plate [D]. Shake a bag of developer and pour it into the development hopper [A]. Follow the correct order.
|Date Added:||13 August 2007|
|File Size:||44.69 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
C28828 the front joint [A] The front joint [D] is firmly set. Open the front door. The steps below included directions for both replacement procedures. You must be logged in to post a comment.
Keep the developer off at both ends of the development unit enclosed in red lines in the diagram. The bearing is properly applied with lubricant.
Savin C2828 Toner Cartridges and Refill Kits
The machine initializes the developer and resets the PM counter for the developer. Turn the machine power on.
Follow the correct order. Pull out the PCU hold the grip while you pull it out.
Printer: Savin C | OpenPrinting – The Linux Foundation
Execute the drum phase adjustment with SP twice. Do not let saivn objects touch the development sleeve. When the development unit is removed from the drum unit, clean the entrance mylar [C] with a vacuum. Open the drum positioning plate [D]. Savin C Black Drum Replacement — On this page is the instructions for the drum and developer replacement. Turn the drum positioning plate lever [B] and the image transfer unit lock lever [C] counter-clockwise.
Majority of print c22828 problems are related to parts of the drum unit.
Lever lock [A] 3. Entering SP Mode 1. Do not touch the OPC drum. Enter the Service Mode. If you change the development unit, do the ACC procedure.
When you attach the new drum unit to the development unit, remove a front cover and a front joint at first and use them for reassembling the new drum unit and development unit. Typically once you begin experiencing color streaks or color back grounding it can be a symptom that the charge grid and cleaning blade are beginning to go bad.
Front cover [A] Do not touch the bearing [A] after removing the front cover. This step removes developer that has stuck to the development roller, which would cause color unevenness.
Otherwise, the hopper cover may be damaged. Remove it with a flat screwdriver. Do the ACC procedure.
The new drum unit has a front cover and a front joint. Reattach the hopper cover hook x 3. Rotate the development roller [A] five or six times in the counterclockwise direction. Remove the bushing [A] of the development roller at the saavin of the PCU 6.
Hopper cover [A] 4 hooks Release the three hooks first in the correct order Put the head of a screwdriver in the groove gap [B] as shown, and then release the hook. Shake a bag of developer and pour it into the development hopper [A]. Turn the machine asvin off. Make sure that the harness [A] is hooked as shown.